Investigation of Fire Effects on Columns of High-Rise Reinforced Concrete Buildings

Document Type : Original Article

Authors

1 M.Sc. of Structural Engineering,College of Civil Engineering, University of Tehran, Tehran, Iran.

2 M.Sc. Department of Civil Engineering, Federation University, Melbourne, Australia.

Abstract

The effects of firebreak in high-rise buildings seem essential to be investigated cautiously since world trade center towers incident. Consequently, many technological advancements were achieved and numerous researches were performed. Nevertheless, in 2017, Plasco building in Iran also was set ablaze and the consequence was the full destruction of the building, claiming lives of at least 20, injuring 70 and loss of thousands of jobs. Therefore, it is crucial to investigate the effects of fire in high-rise buildings more thoroughly in order to prevent progressive collapse, a phenomenon that caused the destruction of the two landmarks. Ordinarily, to achieve this goal, methods of analysing fire effects are developed. So by choosing a logical fire scenario, design fire is extracted from time-temperature relations of design codes. After determining the firing temperature at various times, effects of temperature increase on the material's mechanical properties are investigated. Important characteristics such as concrete compressive strength, concrete and steel modules of elasticity, tensile strength, the coefficient of thermal expansion and steel rebar yielding stress are affected by alterations of temperature. Finally, by analysing structural behaviour utilizing modelling programs and comparing results of different fire temperatures and stories in which fire occurs with the initial design of the building RCC frame, it can be concluded that axial forces increases in columns are the critical condition in fire situations and in case of fire break in distinct stories, lower floors will experience a sharper surge of axial forces. 

Keywords

References

1. Eagar, T.W. and Musso. C. JOM, (2001).  53: 8. Why did the world trade center collapse? Science, engineering, and speculation, Journal of The minerals, Metals, and Materials Society, Vol.53, No.12, 8-11.
2. Khorasani , Zavareh D, Shokouhi M., (2017). Collapse of the Plasco Building due to Fires and its Lessons Iearnt. Journal of Safety Promotion and Injury Preventation, Vol.5, No.3, 120 -124.
3. Eurocode (EN 1991-1-2), 202. Actions on structures.
4. ASCE, (1998). Standard Calculation Methods for Structural Fire Protection, ASCE/SFPE Std. 29-99, Reston, Va.: American Society of Civil Engineers.
5. ASTM, (2000). Standard Test Methods for Fire Tests of Building Construction and Materials, ASTM E119, West Conshohocken, Pa.: American Society for Testing and Materials.
6. ACI Committee 216, (2007).Determining Fire Resistance of Concrete and Masonry Construction Assemblies, ACI 216.1-07, Farmington Hills, Mich.: American Concrete Institute.
7. Harmathy, T. Z., (1970). Thermal Properties of Concrete at Elevated Temperatures, Journal of Materials, Vol.5, No.1,.47-74.
8. Phan, L., and Carino N. J., (2001). Mechanical Properties of High-Strength Concrete at Elevated Temperatures, NISTIR 6726, Gaithersburg, Md.: National Institute of Standards and Technology.
9. Cruz, C. R., (1996). Elastic Properties of Concrete at High Temperatures, Research Department Bulletin 191, Skokie, Ill.: Portland Cement Association.
10. Weigler, H., and Fischer R., (1964). Beton bei Temperaturen von 100 C bis 750 C, Beton Herstellung und Verwedung, Dusseldorf, 33-46.
Advance Researches in Civil Engineering
Volume 1, Issue 1 - Serial Number 1
February 2019
Pages 32-41

Files

Share

How to cite

Statistics